 |
Please Note: When assembling jigs, do not tighten up any bolts until all bolts and plates are assembled. In other words tighten all bolts after plates are assembled on lower.
GEN 3 UPDATES/UPGRADES:
- THE FCG FOR THE .308 SIDE HAS NOW BEEN MODIFIED TO FIT Most DPMS STYLE LOWER RECEIVERS.
- TWO SIDED DESIGN, FLIP PLATES TO GO BETWEEN AR15 TO .308
THIS IS OUR FIRST TRULY UNIVERSAL LOWER JIG KIT. IT WOKS WITH BASICALLY ANY LOWER ON THE MARKET (MULTI-CAL, .308...ETC.). ALSO, SINCE WE HAVE RECENTLY ADDED THE ROUTER PLATE, THIS ALLOWS ANYONE TO EASILY USE THE JIG (KNEE MILLS, ROUTERS, DRILL PRESS, HAND DRILL, DREMMEL...ETC.).
JIG INSTRUCTIONS/MANUAL FOLLOW LINK BELOW UFS GEN UNIVERSAL JIG INSTRUCTIONS
Disclaimer: We
take no responsibility for what any customer may fabricate out of our
cnc machined parts. At this point these parts are completely useless,
unless fabricated further by the purchasing customers. We do not
encourage or condone our customers to make firearms, firearms parts, or
any other weapons out of our machined parts. The purchasing customer is
taking 100% responsibility and acknowledging the fact that this is just a
cnc machined metal part or in other words a paper weight.
Other uses for this machined part:
Paper weight Boat Anchor Center piece Art etc...
The UFS 80% lower receiver jig was designed specifically for the UFS 80% lower receiver. This jig will also fit all other 80% lowers on the market. The kit comes with 3 aluminum jig plates, 1 steel top router plate, and all screws necessary for assembly. THIS KIT DOES NOT COME WITH DRILL BITS OR END MILLS. Please get yours while supplies last.
YOU MAY DOWNLOAD COMPLETE STEP BY STEP INSTRUCTIONS MANUAL BELOW:
PDF JIG INSTRUCTIONS
|
|
 |